Greetings,
I am new to this group though I have been professionally involved in
the electronics industry for 24 years. I am now in a position where
making my own PCB is very compelling. The possibility of using a
direct to copper method seems to be the most straight-forward (the
fewest steps). My question is this: Has anyone done a double sided
board using this method. Any registration problems? Does the primary
side make it through the printer OK when the secondary side is
printed?
Thanks,
Peter
--- In Homebrew_PCBs@yahoogroups.com, "Dan" <danto@...> wrote:
>
> Hi,
>
> Great!
> Then I have some hope to use it for PCBs too...
>
> Thank you and best regards,
> Dan
>
> ----- Original Message -----
> From: Volkan Sahin
> To: Homebrew_PCBs@yahoogroups.com
> Sent: Saturday, December 02, 2006 3:31 PM
> Subject: Re: [Homebrew_PCBs] Using a HP Photosmart D5160 for
direct inkjet printing
>
>
> I have tried MIS pro color black on HP DeskJet 930C it
> was ok and almost similar to Epson results. If you
> look at message archives I think you can find the
> corresponding message. The result of etched board was
>
http://tech.ph.groups.yahoo.com/group/Homebrew_PCBs/photos/view/3c45?
b=11
> Volkan
>
> >....Has anyone tried to use this printer before for
> >direct print PCBs?
>
>
>
>
>
> [Non-text portions of this message have been removed]
>