Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Hello all, I have just found this group and here goes:
I am interested in finding someone to do small runs of boards for me,
from PROTEL Advanced PCB V3 files. Generally single sided, drilled,
tinned, with NO overlay, on Phenolic board (is that the right name?)
Etched or milled would be satisfactory. Most of these boards are for
one off type projects but if larger quantities are needed then I would
be guided by you as to your ability to do them or if I should go to a
commercial maker. I am NOT looking for free work, but am certainly
willing to pay for this service. Turn around of a week would be the
expected time frame.
I could do them myself, but I'm too bloody old to go learning something
new.
I have designs ready for some 4 boards right now, so if anyone is
wanting to make a buck or two, then please let me know your prefered
track width, spacing, pad sizes, any restrictions on board shape, etc,
etc.
Readily available postage to Australia would be the prefered mode of
delivery, Paypal probably the prefered method of payment. Or someone in
Australia would probably be the prefered point of manufacture of said
boards.

Thanks, in advance for the flood of enquiries,
and regards,
Peter Moritz,
Up the bush, By the sea, South Australia.