In my case, I know the only difference was the side of the paper on
which I printed. I used the same printer with the same settings, same
artwork. Printed on glossy side was a disaster; printed on
less-glossy side was _so_ easy [one pinhole.] You might try it again,
just to add another data point.
Thanks for the followup,
Donald.
--- In
Homebrew_PCBs@yahoogroups.com, "Roland F. Harriston"
<rolohar@...> wrote:
>
> dhlocker:
> >
> > I have used Office Max High Gloss photo paper with outstanding
results.
> >
[snip]
>
> The laser jet copy was made on a Minolta machine, normal density, on the
> glossy side of the Office Max paper.
[snip]
> Retouching a few pinholes was required. The image was near perfect.
[snip]
> The second time around, a different laser printer was used at the
UPS store.
> I don't recall the brand name. The Minolta machines were all busy.
> The same Office Max High Gloss paper was used (from the same package).
>
> This time, the paper was very difficult to remove, and I had to
resort of a
> toothbrush to partially remove it followed by a lot of thumb rubbing.
> Some of the toner came off with the paper and I had to retouch
several pads
> and traces with a Sharpie pen. The warm water soak time was inordinately
> long IMHO.
>
> Not nearly as good as the first attempt with Office Max Glossy
> and the Minolta printer.
>
> My conclusion is that the toner makes the difference.
>
> The only variable in the two instances was the difference in the laser
> printers,
> each most likely using a different type of toner.
[snip]
> Comments and suggestions are most welcomed.
>
> Roland F. Harriston
>