On Mon, 02 Oct 2006 01:28:16 +0200, kilocycles <
kilocycles@...>
wrote:
>
> I have to use so much heat with the Brother toner, it re-transfers off
> the copper to the paper towel or whatever I use under the board if I
> do both sides before etching. I wonder what wax paper would do? Wax
> might act as a resist, though. Something Teflon coated, maybe.
Simply do not remove the paper from the other side. I used to align two
papers, put the PCB in between, and feed the stack through the fuser to
transfer both sides at once.
You could also try a silicone or teflon baking sheet...
ST