My hose comes out of the tank above water level, however, I just
coil it up and let it lay in the bucket around the tank. Something
must have got it going to siphon it all out, not sure what or why,
but lesson learned!
I have one of those valves around here somewhere and am going to
have to find it and install it. I would much rather be safe than to
have that kind of mess again.
Apparently, based on the longer etch times, the brass
fitting "consumed" a lot of the strength of the Ferric Chloride as
it melted away into never-never-land :-( I guess I will have to
order up some more powder and make a new batch soon.
Chris
--- In
Homebrew_PCBs@yahoogroups.com, "Stefan Trethan"
<stefan_trethan@...> wrote:
>
> On Mon, 11 Sep 2006 16:04:59 +0200, lcdpublishing
> <lcdpublishing@...> wrote:
>
> > Hi guys,
> > Went out to etch a board this morning only to find my tank
empty -
> > luckily I store it inside a bucket so all was well. The Ferric
> > Chloride siphoned out through the air hose inlet which passes
through
> > a hole in the side of the tank. Aside from it completely
disolving
> > the brass fitting which connects to my compressor, nothing else
bad
> > happened.
> > Just make sure to clamp the hose shut and to store your etching
tank
> > inside another vesel to capture the fluids should the main tank
have
> > problems.
> > Chris
>
>
> Indeed! I had a similar situation, twice ;-)
>
>
> Does the hose leave the tank below or above the etchant level?
>
>
> If you have a second container where it sits in, it is annoying,
but
> imagine what it would be if there was no second container ;-)
>
> For the air hose you could also try a no-return valve like sold
for fish
> tanks to prevent exactly that problem of water flowing back out.
>
>
> ST
>