I've also had better results wiht with the glossy advertising (Sunday
newspaper inserts) than with the Staples inkjet paper. My favorite is the
SEARS insert.
I usually first print the -pcb artwork on regular paper, then using laser
labels, tape a piece of the SEARS ad to cover the printed area. The regular
paper acts as a carrier and feeds through the laser printer neatly.
After removing the paper by soaking, I "flash fuse" the toner, by heating it
with a hair dryer, keeping the hair dryer very close 1/8" or 2mm from the
toner.
The flash fusing seems to help the adhesion and evenness of the toner and
makes it more durable.
TANSTAAFL!
Myc
On 7/12/06, loco_labs <burning_you@...> wrote:
>
> Hi guys,
> just thought i would tell you about my new way of pcb making.
>
> Step 1, Printing the artwork:
> using glossy advertising junk mail like bigW or K-mart papers
> tear out a clean page a bit smaller than A4, about 1cm from the top
> fold the top edge over and hook it onto a standard A4 sheet so the
> advertising is on the top side, and feed the lot into the paper slot
> of a brother hl-2040 laser printer and click print.
> the thin advertising wont jam like this because the normal sheet will
> pull it through.
>
> Step 2, Transferring the toner:
> find a laminator, the one i use is marbig A4 home laminator bought
> from safeway, it has silicone rubber rollers that can squash to
> accept a standard thickness bcb. cut out and align the artwork and
> feed it to the warmed up laminator. feed it in a couple of times to
> make sure the board all hot.
>
> Step 3, Etching:
> once the laminator spits out the board soak in hot water with dish
> wasking liquid and gently rub off bigW's advertising and etch the
> board. printers like the brother hl-2040 have really delicate toner
> so i have to be very gentle.
>
> any laminator should do, the only mod i did was take the top plastic
> cover off so i could get closer to the rollers for feeding tiny
> boards.
> any feedback would be great
>
> -Cheers!
>
>
>
[Non-text portions of this message have been removed]