>I've made a number of test boards containing designs with 8/8 rules -
>-in each case the results haven't been nearly good enough to be
>usable.
A magnification tool (visor, lamp, glass, loupe, microscope etc..)
should go a long way in troubleshooting the problem. Do the following;
1. Examine the printed artwork "nine ways to Sunday" using the above
tool. If there are issues here then it's pointless proceeding with
the exposure step.
2. Examine the developed board as above. If there are issues here
then it's pointless proceeding with the etching step.
3. Examine the etched board as above.
Once you've determined where the problem lies then you can focus on
its correction.
--- In
Homebrew_PCBs@yahoogroups.com, Stuart Wallace <stuartw@...>
wrote:
>