Hi Don,
I use Eagle and Press -N- Peel. I first print out the output of Eagle on a standard sheet of paper. I then cut a piece of Press-N- Peel slightly larger than the output and tape it lightly over the output on the paper and feed it back through the printer. Works great and no waste of Print-N- Peel.
Hope that this works for you - Jack
----- Original Message -----
From: Dell Gillispie
To: Homebrew_PCBs@yahoogroups.com
Sent: Sunday, April 13, 2003 7:12 PM
Subject: [Homebrew_PCBs] Eagle Software Users
Hi:
I am attempting to make a couple boards using Eagle software and Press-N-Peel.
The smallest paper that I can feed my printer is 3" X 5". Even at that size I could print at least two/three drawings per sheet of Press-N-Peel.
Is it possible to get the software multiple copies of the drawing per sheet of paper?
Dell
[Non-text portions of this message have been removed]
Yahoo! Groups Sponsor
Be sure to visit the group home and check for new Bookmarks and files:
http://groups.yahoo.com/group/Homebrew_PCBs
To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]