Dear Volkan,
When I read about your results in direct printing on PCB, I was really
impressed. I am trying to set up an EPSON Stylus C70 printer for this
purpose. The regular paper input however does not allow normal PCB
material of 1.6 mm. How did you solve this problem?
In the C70 there is a way to get a flat path by entering the paper/PCB
below the paper carriage. However, the printer does not accept this.
When I move a page till the paper feed (PF) roller, the presence of
the page is detected but not accepted for printing. It is just moved
out of the printer without being printed. Can you give some hints on
how to create a flat path and a reference position that is accepted by
the printer.
With kind regards,
Gerard Janssen
PS. Sorry when this is more an interuption of the thread. This is my
first post on this forum
--- In Homebrew_PCBs@yahoogroups.com, Volkan Sahin <vsahin@...> wrote:
>
> Hi Stefan,
> I am using Epson CX4200 and I can say that I didn't see any
puddling. If it is possible send me some photos of puddling and let me
compare. If ink amount seems to be too much you can try to adjust
printer settings.
> I am always using 3 colors and each color has 90 nozzles as far as I
remember. I am in office now so I didn't remember all settings, this
night I can check and send you the settings that I am using.
> Volkan
>
> Stefan Trethan <stefan_trethan@...> wrote:Volkan, don't you have any
puddling at all?
> Which printers did you say you used?
>
>
>
>
> [Non-text portions of this message have been removed]
>