low profile ic sockets with small pin spacing like 1,778mm have pins which can be easily extracted and used as vias
:)
Andrew <
andrewm1973@...> wrote:
When you have a prototype to make that
has to be exactly the same layout as the
final board. You have to get it done
as fast as possible. You don't have
real through hole plating at your house.
$40 PER HOLE would still be cheap :D
However I think those packets that cost
$40 have 20 bails in. Each bail has 25
rivets. 500 rivets per pack. So that
is 0.1 dollar a hole.
Not quite so bad. And I am sure it
saves me 0.1 dollars worth of time over
trying to do anything with poking wires
through holes to make vias.
---------------------------------
Yahoo! Mail goes everywhere you do. Get it on your phone.
[Non-text portions of this message have been removed]