Hmm, that's not a bad idea. I know I want something that will not bond or
interact with the engine block paint, so that rules out anything with
petroleum. I had thought of vaseline, but I'm pretty sure petroleum-based
products would have a 'paint thinner' effect around the lands, basically
screwing up the surrounding paint.
I tried hair gel from the corner dollar store. I had high hopes for this
material 'cause it was super cheap, non-toxic and water-based. Only problem
was that it was too soft, it didn't make a nice dome over the land, some of
the lands totally closed over.
Toothpaste has a thicker consistency, that might be just right. I was
looking for an excuse to etch another PCB tomorrow, this is just what I
needed. I'm also going to take the opportunity to pick up some of the
Staples glossy paper for laser printers and give that product a test run.
Robert
:D
-----Message d'origine-----
De :
Homebrew_PCBs@yahoogroups.com [mailto:
Homebrew_PCBs@yahoogroups.com] De
la part de Stefan Trethan
Envoyé : avril 13 2006 16:28
À :
Homebrew_PCBs@yahoogroups.comObjet : Re: [Homebrew_PCBs] RE : Surface mount VS Through-hole comparison
How about toothpaste?
ST