I'll post just once and reply to all...
first to stefan:
I found one dealer who should have this HP high gloss laser paper.
It's just...why is always the best and most expensive ?it only comes
in 200 sheets and costs about 56 euro...i'll go and ask them if they
have it.
i have one old iron which doesn't have steam, but i guess i'll
better check out if it has level surface...otherwise aluminium plate
is a good solution.
i'll try out transparency with cloth protection, as you suggested
and see the results. it's just... Murphy has made sure that (again)
i have plenty of laser transparencies, but i'm out of inkjet
ones...so, out to store you go...
i'll try to get some cheaper version of that famous HP...from posted
it's just too good to be true. If i get it and get some results, i
will post them, too.
--- In
Homebrew_PCBs@yahoogroups.com, "protonceksleeperman"
<protoncek@...> wrote:
>
> Hi folks!
> As all of you, i'm trying to make my first PCB, too. And, as many
of
> you, i too have problems. I tried several papers, (since i'm in
> Europe, i can't get a hold of those mentioned in groups, usually
from
> USA), and most of the times some of the toner peels off, while
last
> layer of paper is very hard to remove. I have measured temp on my
> iron, and it's about 230 degrees, so it is enough. I even tried
with
> lower temp (about 200) but results were the same.
> So, i guess my next try is transparency. But, here i need some
info,
> please. Like what do you do toi prevent transparency to crook
> (distort) from heat? Maybe by applying iron on parts and not on
whole
> board? how long should all last? And would transparency work in
> laminator?
>
> Any of suggestions would be very welcome.
>
> Thanks! Paul, Slovenia
>