Hi Patrick,
--- In
Homebrew_PCBs@yahoogroups.com, Patrick Cambre
<braincambre500@...> wrote:
> I will go ahead today, and get a brand new sheet of
> double-sided PCB at Radio Shack, and then make a
> design from one of my projects at my website.
Where are you located? If you're in the US, you can get inexpensive
copper clad from abcfab on eBay (I'm still waiting for approval to
give out his email address). If you buy, tell him Dennis Louie
referred you. I might get a referral freeby...
> I will let you know how the etchant worked on the
> board, since I am not sure all of the residue was
> taken off.
If you clean the board with 98+% IAP, it should remove any oil that
would cause problems. You can't use drug store rubbing alcohol
because it has too much water and will make things worse.
Are you trying laser transparencies with the hot removal?
Regards,
Dennis