At 01:09 PM 1/22/2006, you wrote:
>--- In Homebrew_PCBs@yahoogroups.com, "alan00463" <alan00463@y...>
>wrote:
><snip>
> >
> > 3. Reverse (L-R) Cu trace artwork image. Print reversed
> > image onto transfer paper, using black toner.
> >
>
>If you are putting the image on the bottom side of the PCB, it should
>not be reversed. Picture what the image will look like viewing it
>through the board. Top copper patterns need to be reversed; bottom
>ones don't.
>
>
>Regards, Bob
This one can really bite you.
It helps a lot to always have some text on the layer to be fabricated to
so you can see if it is mirrored or not..
-carl