you need better heat thransfer equipment.
----- Original Message -----
From: Kim Currier
To: Homebrew_PCBs@yahoogroups.com
Sent: Saturday, January 21, 2006 10:15 PM
Subject: Re: [Homebrew_PCBs] Re: PRess-n-peel blue
Hi everyone. I purchased some press and peel Blue, and tried the first
board. I was not real pleased, but I am SURE it isn't the products fault. I
used the iron on the TOP of the mask plastic. I noticed that the center of
the board was not very good, but the outside edges were distinct, and sharp.
I was applying pressure on the board with the iron, and used a sheet of
paper on the top so that it would move freely.
I was wondering, should i pre-heat the board BEFORE I apply the
press-n-peel? Should I heat the board while I have it on TOP of the pores
and peel, or should I not press as hard as I did to make a good pattern turn
out on the board?
Thanks in advance!!
Kim
Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBs
If Files or Photos are running short of space, post them here:
http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
SPONSORED LINKS Electrical engineering degree online Electrical engineering degree Printed circuit board
Electrical engineering Electrical engineering course Electrical engineering graduate school
------------------------------------------------------------------------------
YAHOO! GROUPS LINKS
a.. Visit your group "Homebrew_PCBs" on the web.
b.. To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
------------------------------------------------------------------------------
[Non-text portions of this message have been removed]