Hi leon,
Where do you get the (fibreglass/paper composite) from? i haven't seen
any in the UK?
Regards
Gary
--- In
Homebrew_PCBs@yahoogroups.com, "Leon Heller" <leon.heller@b...>
wrote:
>
> ----- Original Message -----
> From: "Gary" <questuk1@h...>
> To: <Homebrew_PCBs@yahoogroups.com>
> Sent: Saturday, January 21, 2006 11:32 AM
> Subject: [Homebrew_PCBs] Newbie...how best to cut pre sensitised pcb?
>
>
> > Hi,
> >
> > I'm assuming if you use a hack saw, it will let sun light in at edges,
> > so is there a better way?
>
> I score it deeply on both sides with a Stanley knife, then snap it.
It's
> much easier with the board material I use (fibreglass/paper
composite) than
> with FR4.
>
> Leon
> --
> Leon Heller, G1HSM
> leon.heller@b...
> http://www.geocities.com/leon_heller
>