Eagle does allow you to auto route on one side of the board only. By
indicated "N/A" in the top side under "Autorouter Setup", you will then have
"Autoroute" on the bottom side only.
----- Original Message -----
From: "crankorgan" <john@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Monday, December 26, 2005 2:40 AM
Subject: [Homebrew_PCBs] Re: Milled boards
> Two side is done using two register pins. The problem is you will
> have to add jumpers to make connections from one side of the board to
> the other. With a little thought you can make most boards single
> sided. If you let Eagle route your boards you will get double sided
> boards 9 out of 10 times.