The patttern waa printed on the paper carrrier sheet
further down.
It was an interesting wxpewriment, but any extra steps
defeat the purpose. The foil method works well for me.
Myc
--- James Washer <
washer@...> wrote:
>
> yep, the printer didn't have enough heat to fuse the
> toner...
>
> The question is.... was it smeared when it came out?
> If not... you might be able to fuse it in a toaster
> oven...
>
> - jim
> On Thu, 15 Dec 2005 16:06:49 -0000
> "mycroft2152" <mycroft2152@...> wrote:
>
> > I recently received some very thin pcb material.
> It was 0.5 oz and
> > very flexible, (0.020"?) I could easily curve it
> around a 1" rod.
> >
> > I have an old Laserjet IIp+ laser printer, that I
> have been using
> > for toner transfer. The LJ is old, heavy and built
> like a
> > locomotive, so I thoough I would try printing
> directly on the pcb
> > material. I put in an old cartidge and gave it a
> go.
> >
> > A 3" x 5" piece of pcb was attached to a regular
> sheet of paper with
> > heat proof labels. I slightly precurved the pcb
> material. The pcb
> > matereial ran through the LJ without a hitch!
> >
> > Unfortunately, the toner barely stuck to the pcb
> and was reprinted
> > on the paper. I tried again after an extra
> cleaning step, but to no
> > avail.
> >
> > It appeared that the toner was not fused and was
> still powdery. The
> > fuser in the LJ may not have enough power to
> handle the 0.5 oz
> > copper.
> >
> > So much for a good idea, back to the foil and the
> laminator.
> >
> > TANSTAAFL
> >
> > Myc
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> > Be sure to visit the group home and check for new
> Links, Files, and Photos:
> > http://groups.yahoo.com/group/Homebrew_PCBs
> >
> > If Files or Photos are running short of space,
> post them here:
> >
>
http://groups.yahoo.com/group/Homebrew_PCBs_Archives/ >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com