those drill stands also don't tend to have very high precision bearings or
mechanisms... the amount of wobble or other slop that is acceptable with a
1/4" drill bit is a LOT greater than the amount that's acceptable with a
tiny PCB drill bit...
-Evan
On 11/28/05, Mike Young <mikewhy@...> wrote:
>
> Screwdrivers are built for low-speed and high torque, the exact opposite
> of
> what's needed for drilling small holes. It might be possible to set up a
> gear drive using the hex drive, but that still leaves the problem of
> coupling to the chuck.
>
> ----- Original Message -----
> From: <pinoy_nyc@...>
>
> > I bought this stand since I thought I can use my power screwdriver to
> > drive
> > the built in chuck, but I found out that the nose of the screwdriver is
> > hex,
> > which wont be able to driver the built in chuck, which has a round
> > connector,
> > and assume you'll be connecting a drill chuck on top of it.
> >
> > is there some kind of an adaptor (from hex to round) so I can use my
> > power screwdriver to drive the built in chuck?...
> >
> > I hope you understand what I'm saying.
>
>
>
>
> Be sure to visit the group home and check for new Links, Files, and
> Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
> Yahoo! Groups Links
>
>
>
>
>
>
>
[Non-text portions of this message have been removed]