On Sun, 28 Aug 2005 00:57:39 +0200, curtgood <
curtgood@...> wrote:
> Has anyone tried printing a circuit onto Reynolds Non-stick Aluminum
> Foil, and using that to transfer the toner onto the copper pcb? The
> one attempt that I made looked pretty good, but did not try to etch
> it.
> Transfer was rapid and all of the toner transferred to the copper,
> leaving the silicone coated Reynolds clean, using just the wife's
> electric iron. The aluminum foil released instantly, no soaking or
> rubbing required.
I'm surprised you can print on aluminum foil with any sort of density.
> If you are going to use the wife's iron, be sure that it does not
> touch the toner directly, or else clean it very thoroughly before it
> is used on clothes.
> 73, Curt W4QBU
You mean, make sure you are not seen taking it and clean it before the
wife is back home, else you have to buy a new one no matter if there is
any residue ;-)
ST