I found there is a vast difference in transparency material.
Some break up the image so that fine lines are not possible at all.
Some older transparencies only allowed printing on one side !
So far I have found two type that do work very well.
3M CG3300 is good.
Apollo CG7060 is the best and works down to 5 mil lines using HP LJ1100
at 600dpi
Which software are you using ?
Have you checked the printer settings for "quality" ? I use "Best" and
make sure
Toner Economy mode is Off.
Hans W
stuart.lamble@... wrote:
> Hi All
>
> I am printing my positive image onto a lazer quality transparency
> sheet
> using a HP5000 1200dpi printer.
> The quality on the transparency is rather poor.
> What other paper/transparency can I use?
>
> Stuart
>
> Yahoo! Groups Sponsor
ADVERTISEMENT
>
> Be sure to visit the group home and check for new Bookmarks and files:
>
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]