My ribbon application only took four channels. You could run two ribbons by using all 8 channels which the CVS has. You'd just have to modify the program. There is probably a way to multiplex them to reduce the channel count but you have enough channels to just duplicate for two. The software has to be modified but this should be pretty straight forward.
Note, however, that each ribbon is actually three ribbon mechanisms and I piece them back together for one continuous ribbon. You could modify the program for 3 independent ribbons, or piece them together to make 2 independent ribbons. Just software.
Dave
--- In ComputerVoltageSources@yahoogroups.com, "m0n075" <modular@...> wrote:
>
> Is it possible to connect 2 ribbons to one cvs board?
>
> Cheers,
>
> Dennis
>
> --- In ComputerVoltageSources@yahoogroups.com, "djbrow54" <davebr@> wrote:
> >
> > I went ahead and finished up my ribbon project. I just had to
> > make the interface cable for the RJ-11 connector on the ribbon
> > to my CVS PCB. I created a web page with the schematics and
> > program for this project at:
> > http://modularsynthesis.com/cvs/cvs3.htm