Is it possible to satisfy the input offset and output slew knobs/pots with
programmable offset and slew?
If slew is only used to prevent zippering, then a digitally set programmable
slew per output seems much easier, repeatable, plus saves panel space.
Input offset might be a little more difficult, depending on the usage. If
only used to change from 0-10 volt range to +/- 5V range, then a
programmable function is easy. If used to tweak the nominal value of a
function, let's say four voltage controlled LFOs, then it becomes a
necessity. Opinions appreciated, especially from those who have wired this
function in their PSIM and used it.
I could personally do without MIDI, but it seems that a lot of people want
this feature.
If we were to take a poll, I'd guess that most people would vote for all the
features but want it in a 2U MOTM or standard width Frac Rack panel...
John Loffink
The Microtonal Synthesis Web Site
http://www.microtonal-synthesis.comThe Wavemakers Synthesizer Web Site
http://www.wavemakers-synth.com > -----Original Message-----
> From: ComputerVoltageSources@yahoogroups.com
> [mailto:ComputerVoltageSources@yahoogroups.com] On Behalf Of Grant Richter
>
> I guess we could add the option of a slew limiter for each ouput. If you
> want, populate the
> board and wire you jacks to a differnt set of ouputs. That will add 4 more
> pots and
> possibly 4 more jacks if you want both.
>
> At this point we are up to 12 knobs, 19 jacks, 6 LEDs, three 5 pin DIN
> connectors and a
> DB9 connector.
>
> With 1/4" connectors, that is like half a 19 "rack. Same with Frac-Rac, a
> very big faceplate.
> Then if you add a LCD display somewhere...
>
> Any more stuff and the faceplate will be so expensive it will be too
> expensive for students
> and beginning hobbiests.
>
> For those who want to begin laying out faceplates, the faceplate component
> list is:
>
> Jacks:
> 1 v/oct in 1-4
> Variable CV in 1-4
> CV out 1-4
> Run Pulse in
> Stop Pulse in
> Speech out jack
> Gate out jack
> Trig out jack
> Gate in jack
> Trig in jack = 19
>
> Pushbuttons:
>
> Run / Stop = 2
>
> Knobs:
>
> CV offset 1-4
> CV attenuator 1-4
> Ouput slew 1-4 = 12
>
> 5 pin DIN:
> MIDI in
> MIDI out
> DIN in or out = 3
>
> DB9 for programing interface
>
> LEDs:
>
> CV indicators 1-4
> Run / Stop LEDs = 6 total
>