Wiardgroup

Hi 
i don't know if anybody 'official' answered your question privately
... but i have a pretty-good ruler and frac-rack modules from Wiard,
Blacet and Paia...
  So based on those admittedly INformal qualifications...
(and sorry, but my guage is marked in inches not millimeters)

on a 3-inch (2U) panel:
Horizontally:
the holes on are spaced 1 & 1/2 inches apart (and thus 3/4 inches from
the side edges)
Vertically:
they are 5/16 inches from the top and bottom
Diameter:
the Wiards and Paias are 1/8 inch diameter, the Blacets measure just a
LITTLE smaller between 1/8 and 3/32 inch

again sorry for non-metric tools.
hope that helps

-doc



--- In wiardgroup@yahoogroups.com, "stefanbonnet" <stefanbonnet@...>
wrote:
>
> Hello,
> I finally decided to build a wooden case for the modules I ordered
(may be it will help 
> unifying the mismatching colors/knobs), I just need to be sure the
height/width of a 
> standard module is 133mm x 75.7mm (5.24" x 2.98").
> 
> What are the mounting holes' spacing/position/diameter ?
> 
> thanks
>