The Mellotron Group

Any one got one?
What does it look like?
Can you still get one?

Mark, I can tell you how to make one. All it is for it to help put tapes into virgin frames.

Here's how you make one:

Cut a piece of bals or other wood into a block 1.25 inches X 2 inches X .375 inches. Then get two pieces of spruce or bass wood 18 inches long and 3/8ths" wide and 1/8th inch thick (.375"). Glue the spruce or bass wood strips to the bock along the 2" length. Wrap the block with duct tape. You're done. You now have the tool.

So when are ready to put tapes into a virgin frame, mount the frame into the Mellotron, screwing in the front and back rails. Put the piece of tape into the back rail under the proper screws. Dump most of the rest of the tape into the spill box and slide a few inches of the other end under the proper two screws on the front rail, while making sure that the tape is not twisted. Use the tool to shove the tape down over the front tape guide rollers such that two loops appear down in between the plastic tape separators. Grab the two loops from underneath with your fingers. While holding the loops in proper position with one have, pop open the turnbuckle with the other. Do not twist the turnbuckle; keep it aligned. Pop the loops over the respective turnbuckle spindles and close up the turnbuckle. Do this 34 more times. All the tool is for is to help push the tape down over the front roller guides so that you can grab it from underneath.

Then go to the chiropractor.

Frank.

Create a Home Theater Like the Pros. Watch the video on AOL Home.