Yahoo Groups archive
Thread
2000-04-12 by J. Larry Hendry
You can go MUCH lower and MUCH higher when you add CV Steve. put some positive voltage (maybe from an unused EG) in the CV jack and you can go well into the audio range. Larry H ---------- From: revtor@... One thing about my 320 is bothering me though.. It doesn't seem to be getting to a high enough frequency. I'd say it hits maybe 200hz max.. It's supposed to go alot higher than this.. any thoughts?
2000-04-12 by Paul Schreiber
No, its OK. You are referring to the *panel* control FREQ. If you wack it with 5-6V in the 1V/OCT jack, it will go up to about 4Khz. Paul S.
----- Original Message ----- From: <revtor@...> To: <motm@egroups.com> Sent: Tuesday, April 11, 2000 11:27 PM Subject: [motm] 320 question.. hey, One thing about my 320 is bothering me though.. It doesn't seem to be getting to a high enough frequency. I'd say it hits maybe 200hz max.. It's supposed to go alot higher than this.. any thoughts? All the controls work, the waveshaper works, the thing goes waaay slow, at the low end, but it doesn't seem to run fast enough. I know, I know.. its an LFO. But I just want it to be working 100%. thanks for any ideas as to where to look or what components would be causing this... ~Steve ------------------------------------------------------------------------ Get paid for the stuff you know! Get answers for the stuff you don't. And get $10 to spend on the site! http://click.egroups.com/1/2200/3/_/529958/_/955514534/ ------------------------------------------------------------------------