MOTM

Folks,

The MiniMoe sequencer project page has been updated. All designs not 
under consideration have been removed. The very compact 2U and 3U 
systems have been extensively revised, and are now dubbed "MicroMoe". 

Thanks to all who gave feedback in the last cycle. I feel that 
several of the modules are pretty close to where they need to be, and 
I'm moving on to actual design work on the MicroMoes.

http://www.hotrodmotm.com/minimoe.htm

Moe

What happened to the gate/pulse expander?
John Loffink
jloffink@... 

-----Original Message-----
From: mate_stubb [mailto:mate_stubb@...] 
Sent: Tuesday, March 19, 2002 9:25 PM
To: motm@yahoogroups.com
Subject: [motm] New MiniMoe page up
 
Folks,

The MiniMoe sequencer project page has been updated. All designs not 
under consideration have been removed. The very compact 2U and 3U 
systems have been extensively revised, and are now dubbed "MicroMoe". 

Thanks to all who gave feedback in the last cycle. I feel that 
several of the modules are pretty close to where they need to be, and 
I'm moving on to actual design work on the MicroMoes.

http://www.hotrodmotm.com/minimoe.htm

Moe

I second that motion. How can we make this into a drum sequencer without 
one? I need it in conjunction the way I personally plan to use a sequencer.

Thomas White

>What happened to the gate/pulse expander?
>John Loffink


_________________________________________________________________
MSN Photos is the easiest way to share and print your photos: 
http://photos.msn.com/support/worldwide.aspx

>>>>
What happened to the gate/pulse expander?
<<<<

Temporarily removed until it gets a makeover.

Moe

Question about this:

"When in REV position, a rising edge on the REVERSE jack causes the 
sequence to reverse direction and keep going even after the pulse is 
removed. A second pulse reverses the direction again."

How does one specify the starting direction? Do you first select UP 
or DOWN and then switch it to REV?

>>>>
Question about this:

"When in REV position, a rising edge on the REVERSE jack causes the 
sequence to reverse direction and keep going even after the pulse is 
removed. A second pulse reverses the direction again."

How does one specify the starting direction? Do you first select UP 
or DOWN and then switch it to REV?
<<<<

Yes. You start your module in a known state by setting the direction 
explicitly with the switch. If I had more panel space, I'd probably 
put a separate UP jack and DOWN jack.

Moe