MOTM

Anybody built one yet (after ALL that hard work I put in shipping them out)? Caught the typo in
the resistor color codes, wondered if there were any other issues.

Paul S.

All I have left to do is attach the wiring to my jacks on my two.  Pooped
out at 1:30 AM.  Honey-do projects today.  But, I will have mine up and
running tonight.  Then I will try the breath controller mod installation.
:)
Larry Hendry

----- Original Message -----
From: Paul Schreiber <synth1@...>
Anybody built one yet (after ALL that hard work I put
in shipping them out)? Caught the typo in the resistor color
codes, wondered if there were any other issues.

Paul S.

h3y,
mine works fine.  jes' finished it.  i noticed no issues.
no pedal to check it out, but everythin' else works beautifully.  
hmmmm, maybe i should pick one up.  it does work with the CV out on 
my spacebeam...
have a good one...
peace,
doc


--- In motm@y..., "Paul Schreiber" <synth1@a...> wrote:
> Anybody built one yet (after ALL that hard work I put in shipping 
them out)? Caught the typo in

> the resistor color codes, wondered if there were any other issues.
> 
> Paul S.

You can use any CV into the pedal input.  When you plug CV into the pedal
jack it does not matter how the jumper is set.  So, if you have it set up
for Yamaha, you can alternate back and forth between Yamaha and CV without
any jumper change.  So, the pedal interface can be used for a nice 2 IN, 1
OUT, DC mixer with built in offset.  :)
Larry Hendry
P.S. buy the Yamaha pedal.

----- Original Message -----
From: <doc@...>
To: <motm@yahoogroups.com>
Sent: Wednesday, November 14, 2001 6:48 PM
Subject: [motm] Re: Pedal Interface OK?


h3y,
mine works fine.  jes' finished it.  i noticed no issues.
no pedal to check it out, but everythin' else works beautifully.
hmmmm, maybe i should pick one up.  it does work with the CV out on
my spacebeam...
have a good one...
peace,
doc


--- In motm@y..., "Paul Schreiber" <synth1@a...> wrote:
> Anybody built one yet (after ALL that hard work I put in shipping
them out)? Caught the typo in
> the resistor color codes, wondered if there were any other issues.
>
> Paul S.





Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/