MOTM

>You are all confused.

Me too...list crossover. Yikes.

>The original post talked about .156 connectors (MOTM and Oakley
standard for POWER connections, and additional .100 connectors for
bussing KBD and GATE signals.

Actually, I just checked and I didn't say it directly, just sort of
inferred it. But you are quite correct. The power bus would of course be
0.156" connectors. The CV and gate would be 3-way 0.1" types, small
enough to be ignored if not wanted.


Cheers,

Tony

Tony -

I read this with interest on the Oakley list.  Forgive the silly 
questions but I want to make sure I understand.  The CV and Gate 
connectors would allow me to 'pre-patch' CV and gate signals in a 
routing that I would normally use. But by patching using the jacks I 
could override the 'pre-patch' Correct?

Also, I use a mult to distribute CV and Gate currently.  Would this 
board offer the ability to 'pre-patch' multiple CVs and Gates?

Thanks!

Mike

--- In motm@y..., "Tony Allgood" <oakley@t...> wrote:
> >You are all confused.
> 
> Me too...list crossover. Yikes.
> 
> >The original post talked about .156 connectors (MOTM and Oakley
> standard for POWER connections, and additional .100 connectors for
> bussing KBD and GATE signals.
> 
> Actually, I just checked and I didn't say it directly, just sort of
> inferred it. But you are quite correct. The power bus would of 
course be

> 0.156" connectors. The CV and gate would be 3-way 0.1" types, small
> enough to be ignored if not wanted.
> 
> 
> Cheers,
> 
> Tony