MOTM

Works great Larry!  Thanks.  Now for the question..  I pulled out my 300 
Schematic to update it and rang out the via the mod takes place on and 
found that the via connects pin 1 (square pad) of VR1 (Fine Pot) to 
-15V.  Correct?  The schematic is showing pin 1 connecting to +15V.  Am I 
reading this wrong?

-dave-

At 02:17 AM 1/1/01 -0600, you wrote:
>On my stock MOTM 300s, the range of the fine tune control is about 11
>semitones.  I wanted something in the 2 to 3 semitone range on that control.
>The modification is simple and virtually non-destructive. It requires adding
>one 270K resistor to the circuit board and cutting one trace.  Since the
>trace resides between two via holes, the modification is easily reversible
>by removing the resistor and inserting a wire jumper.