MOTM

My guess would be that it would use any fonts that you could successfully
integrate into Windows. So if Windows loads 'em, Visio should use 'em. 

 -----Original Message-----
From: 	binky beetlebaum [mailto:binky_beetlebaum@...] 
Sent:	Wednesday, 06 December, 2000 2:32 PM
To:	motm@egroups.com
Subject:	[motm] OT Visio

Some may recall that recently I was looking for Cyrillic Dry transfer
lettering.  I've given up on that quest & decided to go digital.

My questions:  how would Visio be for designing gauge faces in Cyrillic?
Is it a relatively straightforward & easy program?  Does it support 
Cyrillic?  Is Version 4.0 adequate or should I be going for 5.0?

Thanks
tomr