MOTM

> You mean that the 800 can be triggerred through a full ADSR cycle
> from just
> a gate signal by adding a jumper? How? Where? All of my current
> controllers
> just provide gates (MAQ, Doepfer A-190 & 191, JKJ CV-3), and I've been
> using my 800's in ASR mode since I built them.

Yep.

Originally posted by John Speth:

>>>>>>>

M800: Solder a wire from the collector of Q1 to the unused pin of the
trigger jack. I tack soldered a wire from R1 on the component side to J2
and tie-wrapped it down. This allows the EG to function as a complete ADSR
with only a gate signal and no trigger. It will function as shipped when a
trigger plug is inserted. I'm surprised this wasn't designed in. I wonder
if it might be better to use a series resistor of about 5K in this wire to
protect against transients when inserting and removing a trigger
plug.<<<<<<<

Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@...