MOTM

Hello MOTMites! ;) 

Some folks were interested in something like this:

http://www.blacet.com/BlacetMOTMadap.gif

This would allow you to place a Blacet module in the cutout and add up
to 8 1/4" jacks on the bottom. There is a white SS over the jacks so you
can presstype or mark the jack functions. They would look pretty much
like a MOTM panel. I need to see some finish samples at the shop to make
sure.

Doepfer looks like a fit vertically (new mounting holes), but width
wise, you would have to remove a bit of material (~0.1"?).

I got a quote back today from the metal shop. They would be $18 each.

Comments? Orders? (It's about a $1000 investment, so definite preorders
in reasonable quantities are a must. Delivery is 4-5 weeks.) 

Regards.
-------------------------
John Blacet
Blacet Research Music Electronics
http://www.blacet.com
-------------------------
blacet@...
-------------------------
Are you on our mailing list?
http://www.blacet.com/mailform2.html