MOTM

I drilled all of the non 1/4" holes to accomodate 1/4" jacks. worked just 
fine. I too used the Chris List design for 1/4" capability on the ASM-1. 
Just finished it, haven't even calibrated it yet. Hoping it will compliment 
the MOTM well.

>From: thudson@...
>Reply-To: motm@egroups.com
>To: motm@egroups.com
>Subject: Re: [motm] Purchasing decisions
>Date: Wed, 05 Apr 2000 13:20:13 -0400
>
>improv@... wrote:
> >
> > Sounds like a godlike system.  Hey, wait a few weeks and you might get 
>the
> > 1000th module prize. My only comment is whether you really need the 940
> > patch panels.
>
>I'm wondering about this too. I may only get one of these. I was only
>getting it for the mults at the bottom. I wonder if it would be
>possible to drill out the 1/8 and banana holes for 1/4 jacks.
>All the other gear I will interface with is 1/4. I even built
>my ASM-1 with the Chris List faceplate to use 1/4. Though after
>seeing what an ASM-1 went for on eBay recently, I may use it
>to fund more MOTM purchases :-)
>
>Thomas

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com