What I would suggest (ROHS or not) would be to take an old (ie, not used
for anything other than electronics) sponge (or rag) and some powdered cleanser
(eg: Ajax) and water, and give the boards a little scrub to brighten up the
copper and remove any tarnish/oxidization.
Am I wrong to do this?
JB
Merry Christmas too all.
In a message dated 12/24/2010 11:50:27 A.M. Pacific Standard Time,
megalists-1@... writes:
These parts and PCB's are a good five years old, so I'm sure everything
is pre ROHS, but wanted to know if I need to do any prep work on the
parts leads or boards.
Any suggestions or just fire up the iron and let the flux do it's job?