MOTM

Yup - had the same problem (informed Cynthia about it as well right  
when they came out). I drilled out the holes and swapped out the top  
pot with a 16mm variant. The info I got from Cynthia is below:

=========================================
24mm Aplha Linear 10K from Mouser

31VA401-f

http://www.mouser.com/

that is a 24mm pot which is too big apparently...

a smaller pot that would fit and have the same feel is
a smaller 16mm Pot instead of 24mm

The 16mm Alpha pots I use for most everything is

31JN401-F
=========================================

-greg

On Jul 18, 2009, at 4:11 PM, Miguel Mendoza wrote:

>
>
> Hello group, any of you are using one of these in a flat rails  
> mounting cabinet? I didn't see this comented before but this module  
> doesn't fit into a typical cabinet. The Alpha pot for the 'FAT'  
> feature is too big, the PCB also seems a little larger than usual  
> but I think that replacing the pot will work. Anyone fixed this? Do  
> you know if this potentiometer is linear or logaritmic?
>
> Even the screw holes are so small that I had to drill them again...  
> Really annoying.
>
> Thanks!
>
> Miguel.
>
>
>