MOTM

I am wondering if anyone can show me an example of using MOTM rack rails 
to mount modules in a rack that can be ported around.  I have looked at 
typical 19-inch road cabinets and found that most of them are either too 
deep or too short to be well suited.  A 12-inch depth should be adequate 
for any module, even with Stooge long brackets.  Ideally I would like to 
have three 10U wide rows of 5U height modules.  That would be a tall 
case, about 30 inches.  I am thinking of using a second road case for my 
Mackie 802-VLZ3 mixer and three 1U height pieces of equipment (MPX-1, 
flash recorder, and power conditioner).  I would consider going with two 
two-tier cabinets of 10U width.  My studio has 130U of modules, and I'd 
like to be able to take at 30 to 40U with me.  20U would be a bit austere.

Any suggestions appreciated.

TIA,

Richard Brewster
http://www.pugix.com