MOTM

That is right.  Even the digital and analog grounds of modules like the 
MOTM-650 are connected together at the MOTM-950 power distribution 
board.  This easily confirmed by an ohmmeter.

Richard Brewster

Mark wrote:
> There is only one ground.  The two ground pins are connected to each
> other at each module, and the two ground wires are connected at the
> power supply.
>
> The only MOTM modules that use two grounds, are the digital modules
> that use 5V.
>
> On 9/27/07, randaleem put forth:
>   
>> Hi MOTM'ers!
>>
>> Quick question for y'all,
>>
>> Does the MOTM system use a clean/dirty GND? The two GND pins suggest
>> it, but perhaps not?.
>>
>> If there is a separate dirty gnd pin, which of the two pins is
>> considered the dirty gnd? (The one next to -V or the one next to +V?)
>>
>> Continuing, if there is a dual gnd setup: Do all MOTM modules respect
>> this division of the return paths?
>>     
>
>
>  
> Yahoo! Groups Links
>
>
>
>
>