MOTM

In a message dated 12/10/99 1:22:13 PM, evening@... writes:

>From: "jmw/cmu" <evening@...>
>
>I've been using a Mackie  1202vlz ( ~$250 used) as a mixer for my MOTM
>system
>and have found the flexible routing of the FX, monitor, Alt 3/4 &  solo
>buses to be very user friendly.
>I use my rig mainly for processing.
>I have my 410 & 420 filters connected to the FX sends & a 120 to the monitor
>send.
>The "top mount" locations of the jacks make patching simple. The 4 mic
>pre's
>& 4 stereo in's make connecting other sound sources a breeze.
>
>I plan on modding the board so that both FX sends are pre-fader. (right
>now
>only FX send 1 is switchable).
>
>For my money, it can't be beat  - You can even replace the knobs with those
>little Rat Shack/Alco PKES lookalikes for a not-quite-MOTM look...
>

Aren't the signal levels different? Like 1V p-p as opposed to 10V p-p? I've 
never tried this, I just always thought the two levels were "incompatible." I 
know there is the option of setting the input level for the 410, but did you 
do the same with the 420? 

JB