MOTM

On Sunday 04 December 2005 18:07, djbrow54 wrote:
> A flat piece of metal. The "I" referred to the shape, not
> the cross section. It is held in by the two side screws
> of the module plus the two side screws of the adjacent
> module.  To replace a module you'd need to take out 8
> screws but the adjacent modules would stay in place since
> they still had 2 screws each on their other respective
> sides.
>
> Nothing behind the panel, nothing in-between to change
> the spacing, simply a decorative piece of trim sandwiched
> between the screws and the modules on the surface.  I put
> a drawing in the files section. 'vertical.jpg'

That's a very nice idea!

Not sure about the cosmetics though. The construction near 
the screws could be ugly, especially since I'm looking for 
a very subtle separator. I think a single white or metal 
colored line, the width of the graphic lines on e.g. the 
MOTM-300 would be more than adequate. Anything thicker will 
probably not look very sexy, but I'd love to be wrong here.

- Robert