MOTM

In the '300 manual I have, 7/25/99 revision, page 16, the steps are listed
in the exact opposite order of what you wrote below.

The very last step of the "Attach PC Board to Bracket/Panel" section says
"Remove the hex nuts on VR1 & VR4. For all of the pots, first put on the
flat washer, then the hex nut. Tighten with a 1/2" nut driver."

The step before that said to push the PCB as close to the panel as possible,
hand-tighten nuts on the top and bottom pots, then tighten the 4 KEPS nuts
on the bracket.

Hope this helps,
Chris

On 7/28/05 4:43 PM, "synth1@..." <synth1@...> wrote:

>> 
>> I'm still not quite sure what happened, as the pot was flush to the PCB,
>> and
>> I thought I had the board and bracket and everything tightly assembled as
>> spelled out in the instructions, but alas... Anyway, I hope others learn
>> from my mistake.
> 
> 
> You tightened the 4 pcb mounting screws (to the black bracket) first. You
> need to do this *after* you tighten the panel pots.
> 
> In the older manuals, I will have to check to see if I specifically state
> this. I know I do on the last several manuals.
> 
> Paul S.
> 
> 
> 
> 
> 
> Yahoo! Groups Links
> 
> 
> 
> 
> 
>