MOTM

I appreciate the feedback I am getting.  Here is a clarifications on
mounting that may not be obvious:

The PCB mounts from the DB9 connector.  So, the DB9 connector is an
important part of the front panel.  Even if some remote rear connection were
provided and Stooge jack only brackets were utilized, there is no place on
the PCB for mounting screws.  No place at all.

The DB9 connector is on the right side of the PCB, not the middle.  So, any
design has to allow for that.  The PCB is ssmall enough (only 2.5" wide)
that it can run up-and-down or side-to-side.  But, side-toside, cannot be
centered.

I hope this helps.  Keep the useful feedback coming (only if you plan to
order one of course). :)

Larry