hello all
for CV control of a Lexicon Vortex via the pedal input:
wire a TRS jack Tip=signal / Ring=not connected / Sleeve=screen
the Ring sends a +5v source from the Vortex - the service manual claims "a
50k pot will sweep the full range". As far as CV control of Vortex goes, it
says "control voltage can be used but only 0-5v will apply instead of 0-10v.
voltages over 5v will be tied to 5v"
i must admit, i've not done it for ages, but with nice long lfo... ...well
you can imagine
glad you (thomas) like the FFWD album, the 3D effect is likely to come from
a Cyclosonic Panner (by "Songbird" i think) it was a bit of an Orb favourite
meanwhile, I can announce the winners of the FFWD competition, while I was
cursing away at a little red box, David Bivins said yes (erm i'll need your
address matey), and a certain Mr Schreiber contacted me...
for CV control of a Lexicon Vortex via the pedal input:
wire a TRS jack Tip=signal / Ring=not connected / Sleeve=screen
the Ring sends a +5v source from the Vortex - the service manual claims "a
50k pot will sweep the full range". As far as CV control of Vortex goes, it
says "control voltage can be used but only 0-5v will apply instead of 0-10v.
voltages over 5v will be tied to 5v"
i must admit, i've not done it for ages, but with nice long lfo... ...well
you can imagine
glad you (thomas) like the FFWD album, the 3D effect is likely to come from
a Cyclosonic Panner (by "Songbird" i think) it was a bit of an Orb favourite
meanwhile, I can announce the winners of the FFWD competition, while I was
cursing away at a little red box, David Bivins said yes (erm i'll need your
address matey), and a certain Mr Schreiber contacted me...