MOTM

I ordered the Kenton pro2000 rack ears from Paul so I could get this thing
properly racked.  Paul and I had discussed the idea of drilling these ears
to provide front panel 1/4" jacks.  I did this and it works quite well.  If
you put only 1/4 jacks, you can get six on each ear and use the same 7/8
wide spacing used on the MOTM modules.  In the rack, they actually line up
right under the MOTM jacks.  However, the up and down spacing has to be
reduced.  I used 13/16 center to center.

Instead of 6 jacks on one side, I went for 4 plus a single MIDI jack.  So,
I got the 2 channels of CV and gate and MIDI IN on one side and the 6 aux
voltages on the other side.  I figure I wont need the other stuff on the
front panel.

Larry H