MOTM

> Ken.Tkacs@... writes:
> 
> Speaking of cabinets, I just got some rack rails in from
> Tech America and am disappointed. They're heavy duty,
> but have a huge radius in the bend that will leave a 1" gap
> between my module rows if I use them. I wasn't allowing
> for that in my cabinet blueprints. I hate buying hardware 
> through catalogs without holding it in my hand first.
>
> From: JWBarlow@...
> Since I mentioned getting my 21U rails from Tech Am
> previously I feel a little guilty about what you said regarding
> the 1" gap. This isn't what I found though upon inspection. 
> I set both the rails next to each other as if I had bolted them
> together. Then I lined up spare MOTM panels on adjacent sides 
> of each rail. I then measured the distance between the two 
> edges of the panels which I believe to be about 1/4". 

I got a pair of rails from Musician's Friend and experienced about the same
results as JWB.  Like Ken, I was hoping they would allow the modules to be
flush (like the nice ones that Paul makes).  However, they did not, so I am
not certain I am going to use them for that purpose.  I still have room for
12 more 2-space wide MOTM modules in my rack even after I get my two 320s
before I have to move to a case, so I have a while before I have to cross
that bridge.

Larry H