MOTM

It's just a pot *in series* with the pitch-bend pot! Make it the same vlaue
as the pitch-bend
one, and you can get a decent range.

Paul S.

-----Original Message-----
From: hodad1@... <hodad1@...>
To: motm@onelist.com <motm@onelist.com>
Date: Wednesday, October 20, 1999 12:04 PM
Subject: [motm] Pitch bend intensity?


>From: hodad1@...
>
>Ok, this is slightly off topic, but...
>As I mentioned once before, I took the mod/bend wheel assy. from a junk
>Polysix
>& made it an out board controller for my MOTM--I feed voltage into it from
>the 800 EG
>& send it out to wherever.
>My question:  The Polysix has a Bend Intensity pot on the panel that
>controls how strong a
>pitchbend you get.  What I'm trying to figure out is if I can make this
same
>principle work on
>my little mod controller.  Would the pot need to be wired on the ins or the
>out?  Is there
>a need for additional circuitry?
>I'm sure this would be fairly simple to figure out if I understood
>electronics better, but
>I don't, so I'm throwing it to the panel of experts in the hope that they
>can guide me out
>of the darkness.
>
>Thanks
>tomr
>
>>