MOTM

Can't let a day go by without a post now can I.

In a message dated 9/17/99 9:13:55 AM, johns@... writes:

>2. Dirty coarse freq pot? - I noticed that when I turn the coarse freq
>pot 
>I hear a little dirt in the sweep of the frequency of the VCO.  I was 
>hoping for a good clean sweep just as if a freq CV input sweep was driving
>it but it sounds to me like the coarse freq pot is dirty a bit.

I'm going to ask how if you're using the heat shrink tubing over the 
connections, and if so are you using a heat shrink gun? I'm quite sure I 
cooked the CV MOD pot on my MOTM 110 by using the soldering iron near the 
tubing in order to shrink it -- the pot only burned out in one small area at 
the far clockwise side, and was therefore very difficult to figgur out what 
was wrong. If you get desperate for a solution, you might try disconnecting 
the pot and subbing in any (new) pot of the same value to see how it behaves, 
and if it works, replace the pot.

And of course do everything that Dave, Larry, and Paul have already said.
JB