MOTM

hello all,
as threatened several weeks ago, i've gone ahead and had some motm format
blank panels made
1U & 2U in unfinished 3mm aluminium (ie aluminium coloured)
these have been guillotined and the four mounting holes have been drilled
and de-burrred
one side of each panel is 'clean' and protected by pvc sheeting, the reverse
is not

there is only a limited amount available as i wanted to test the water / get
a few diy panels / not get hooked up with the panelshop from hell

prices are \ufffd2-30 for a 1U panel / \ufffd2-60 for a 2U panel
postage is extra, and economics dictate that these panels are only really
cost effective in UK & Europe (chaps in the USA can get panels from stooge
larry)
a single 1U panel is 90g and hence will cost 41p to post first class within
the UK

any takers..?
please email me privately, i'm contactable until monday then i'm off for a
week

also, i'd very much like to know who would be interested in getting custom
dry transfers made (rub on a'la letraset)
of calibration marks for pots (was this ever discussed before..?) initial
enquires indicate that the markings will be between \ufffd1-50 & \ufffd2-00 per pot -
expensive, but they'll look damn good
if i did this, i'd be looking at black markings - any interest..?

cheers
paul b
sheffield / uk