MOTM

Howdy All -

For the 20 or so folks who are going to build Todd's kit, here's a 
heads up and a question.

First, the heads up: make sure you correctly orient the PCB on the 
Stooge braquet before you cut and solder any of the connections.  A 
dry one is fine, no need to bolt it down.  The issue is that the PCB 
was meant for the OMeg pots with brackets, so the PCB on the Stooge 
Bracket will be backwards with the pot pads on the other side from 
the pots.  The power connector will then be up almost against CV pot 
1.  You can mount it upside down, then the pot pads willbe CV3 up 
with CV 1 down and you'll have to cross the wiring.  Also in this 
case, the socket connections will be at the top of the module 
requiring long cable runs.

Whichever way you choose, measure twice and cut (and solder!) once...

Now the question: the kit comes witht the pieces-parts for the power 
cable and the connector to the 410.  The connectors are some sort of 
compression-fit deal, you can't solder them.  I believe you're 
supposed to press the cable into place and this will cut the 
insultaion and make contact.  The problem is, I can't figure out how 
to do this!  Paul told me once a while back ago that making your own 
power cables required a special tool.  I did buy a hand tool that is 
supposed to do this (it looks like a big plastic "T") but I can't 
figure this out.

Any help on this?

Mike