MOTM

The output level depends a great deal on the settings.  I many settings, the
level is quite low compared to the input signal amplitude.  However, in the
lower end of the frequency settings, output levels and easily be 13 V
peak-to-peak with a singe MOTM VCO feeding in.  So, if you cranked up the
gain in the circuit for the other situations, these settings would surely
cause clipping.  So, I expect your 410 is normal.  Even on the dry setting,
with about 9 volt peak to peak input, I have only about 4 - 5 volts
peak-to-peak output on mine.  These are just my observations.

Larry Hendry

----- Original Message -----
From: phaeton777 <phaeton777@...>
To: <motm@yahoogroups.com>
Sent: Saturday, January 19, 2002 11:37 PM
Subject: [motm] MOTM-410 Gain question.


I've noticed for a while now that my 410 doesn't have a lot of
output. I'd say it was quite feeble compared to the 440. Has anybody
else noticed this? Do I have a problem with my 410?

Cheers,

Richard.







Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/